Valcom PagePac Plus V-5323100 Manual page 6

5. Set Telephone Mode switch on Controller to match host telephone system interface port type.
See Figure 10.
6. Connect cable from host telephone system to Controller Page Input.
See Figure 11.
Note: Depending on the type of host telephone system interface port, the connection may differ slightly
from the illustration to the right. A direct 4-conductor cord from the Controller to the telephone system
can also be used, bypassing the connector block.
7. Connect two wires from the night bell analog station port on the host telephone system to Controller
night bell (N.B.) input. See Figure 12.
Technical Manuals Online! - http://www.tech-man.com Technical Manuals Online! - http://www.tech-man.com
Figure 10. Setting Controller Telephone Mode Switch
Figure 11. Connecting Host Telephone System to Controller
Figure 12. Night Bell Connection to Controller
firealarmresources.com
CONNECT GREEN WIRE TO SYSTEM TIP T
CONNECT RED WIRE TO SYSTEM RING R
CONNECT BLACK WIRE TO THE PAIRED DRY CONTACT CONTROL LEAD GROUND
CONNECT YELLOW WIRE TO THE PAIRED DRY CONTACT CONTROL LEAD C1
BLACK
GREEN
RED
YELLOW
6 947180