Valcom PagePac Plus V-5323100 Manual page 25

9 0 PASS DTMF TO THE OUTPUT
This zone output option enables the Touchtone telephone keypad tones (DTMF) to be passed through
the Controller and output to a second controller or other auxiliary device.
The choice is YES/NO, with the default being NO. Operating the unit in the default mode, you may
switch from zone to zone (within the same Controller) without hanging up, simply by dialing the zone
number of the zone you wish to switch to. The DTMF tones you dial will be muted (not sent out as audio)
as soon as they are detected by the controller.
Access to the first zone will be disconnected when the zone switch has been accomplished
When you have accessed a zone with this parameter set to YES, DTMF will be sent out as un-muted
audio but the Controller will not respond to the DTMF tones (and will not switch zones).
This YES option, with DTMF tones enabled to the output, is useful when you have more than one Con-
troller connected in a system. The DTMF tone is passed through the first controller (not triggering a zone
change) to the second controller (or other auxiliary device).
You will need to repeat this procedure for each output zone or zone group that you wish to receive the
DTMF tones.
1. Dial 9 0 to select this option.
Hear a DOUBLE beep.
2. Enter the zone or group zone number.
Hear a DOUBLE beep.
3. Enter 0 for NO (Not pass DTMF) or enter 1 for YES (Pass DTMF)
Hear TRIPLE beeps.
4. To verify the status of DTMF Pass for a given zone, dial 9 1 and repeat steps 2 and 3 above.
INPUT ZONE/GROUP OPTIONS
These options apply to zones or groups already configured as inputs (see Type of Zone, Step 17). These
options are summarized in the Programming Quick Reference Chart, at the end of this section.
9 2 TONE SELECTION
If a zone is configured to be an input and is activated, then a tone may be selected to be directed to
whatever zone(s) are selected in Tone Routing, below. The tone selections are listed in step 3.
For example, you wish to have a doorbell pushbutton input cause a chime to be heard in certain zones.
You have already configured the zone of the doorbell as an input zone. You need to select the tone
(chime) you wish to be heard in the output zones, when the doorbell is pressed. This is called Activate
Tone via an Input Closure, on the Quick Reference Chart.
The default setting for this option is NONE (not activated).
1. Dial 9 2 to select this mode option.
Hear a DOUBLE beep.
Technical Manuals Online! - http://www.tech-man.com Technical Manuals Online! - http://www.tech-man.com
25
firealarmresources.com
947180