BLOTZ B10-CS-208 Quick Start Manual

10mm octagonal building foyer

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due

care and remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold

pieces in place while you allow glue to dry.

Remove two of the supports and one wall section

from the sprue as shown. Note each section has a

notch in it. This will be at the top of the wall.

Glue two more wall sections to the supports as

shown.

Take one of the supportx with a short arm and a

normal support then....

Repeat this on the other side so you end up with

a gap in the lower ring of supprts as shown.

10mm Octagonal Building Foyer

B10-CS-208

Please read these instructions fully before starting construction.

Turn the wall over and glue the two supports into

position on the back of it.

Then glue two more supports to one of the walls as

shown and add two more wall sections.

...glue these to the end wall section, with the short

arm being at the bottom (see pic).

Now glue the door section into place.

Table of Contents

Do you have a question about the B10-CS-208 and is the answer not in the manual?

Page 1 10mm Octagonal Building Foyer B10-CS-208 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 2 Glue the porch into place. Starting with the door section, glue the wall covering into place, aligning it with the etched pattern. Work your way round the building adding each wall cover in turn. The completed foyer section.
Page 3 10mm Octagonal Building Middle B10-CS-259 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 4 10mm Octagonal Building Roof B10-CS-309 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.