BLOTZ B10-CS-209 Quick Start Manual

PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer
Remove the inner front wall, its "roof" and two
door frames from the sprue.
Now remove the two side walls from the sprue.
Glue the outer front wall into place.
Glue the whole model to the base. Note there is
a "B" etched into the base which should be at the
back of the building.
10mm 3x3 Tower Block Foyer
B10-CS-209
Please read these instructions fully before starting construction.
Attach the wall to the "roof" then glue the door
frames in position as shown.
Glue the side walls to the inner front wall assembly,
aligning it using the holes/lugs provided.
Then attach the back wall.
Glue the door frames around the side doors and on
the back of the building.