BLOTZ 10mm Skyscraper Dice Tower Manual

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember

to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Take the pieces shown above from the sprue.

Then glue the other side piece into position.

Glue these into place.

10mm Skyscraper Dice Tower

B10-CS-023

Attach the ramps to one of the side pieces (see pic)

Take the two end strips.

The inner bracing supports.

Table of Contents

Need help?

Do you have a question about the 10mm Skyscraper Dice Tower and is the answer not in the manual?

Page 1 10mm Skyscraper Dice Tower B10-CS-023 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 2 Attach two supports as shown – the etched line on Take these four roof pieces. them should be facing away from you (towards the top of the model). Turn the model over and attach the other two supports. Glue them together (see pic). Take two of the inner skin pieces.
Page 3 Glue the final section of inner skin into position. Take the four outer skin pieces and glue them into We suggest you paint your model at this point (see position around the model. below) Painting Once the inner core of the building was complete and the glue had dried we sprayed the entire structure silver with an aerosol / rattle can –...

B10-cs-023