BLOTZ B10-CS-203 Quick Start Manual

PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Remove the front wall section, window pieces
and corner bracers from the sprue as shown
above.
Each side wall is formed from the pieces shown
above. Glue the windows behind the wall section.
The porch is made from these pieces.
The add the legs.
10mm 5x3 Office Block Foyer
B10-CS-203
Please read these instructions fully before starting construction.
Glue the windows behind the wall as shown, then glut
the bracers to the back of the wall.
The rear wall is formed the same way.
Glue the pieces together to form a square.
Glue the canopy pieces to the front wall.
The completed foyer.