Water Hardness - Electrolux EVE602 User Manual

50 electrolux.com.au
STEAM ASSISTED COOKING
Tank Emptying
Use this function after cooking with a steam heating
function to remove the residual water from the water
drawer.
Before you start:
• Turn off the oven and wait until it is cold
1. Place the deep pan on the base of the oven.
2. Select: Menu / Cleaning / Steam maintenance / Tank
emptying.
Duration: 6 minutes
3. Turn on the function and follow the instruction on the
display.
4. When the function ends, remove the deep pan.
When this function works, the lamp is off.
Always remove tray for normal cooking or enamel damage
may occur.
Any residual water on the cavity should be cleaned off with
a dry cloth to avoid staining of the enamel. If there is a stain
on the cavity, it can be removed by placing paper towel
soaked in vinegar solution on the stain. (Equal parts of
water/white vinegar solution).
(CONTINUED)

WATER HARDNESS

How to set water hardness:
When the oven is first turned ON, the water hardness level
needs to be set. The default value in your controller is 4. To
lower or increase your water hardness value, follow below
procedure.
1. Go to menu.
2. Press: Settings
3. Press: Set up
4. Select water hardness value using the table below as
a guide.
Contact your water supplier to check the water hardness
level in your area if you are unsure.
The table below shows water hardness range (dH) with
the corresponding level of calcium deposit and the water
classification. Adjust the water hardness level according to
the table.
Water
Calcium
hardness
deposit
(mmol/l)
Level dH
1 0-7 0-1.3
2 8-14 1.4-2.5
15-
3 2.6-3.8
21
4 ≥22 ≥3.9
When the tap water hardness level is 4, fill the water
drawer with still bottled water.
Calcium
Water
deposit
classification
(mg/l)
0-50 soft
moderately
51-100
hard
101-150 hard
≥151 very hard