Hand Held Products Dolphin 7400 User Manual page 103

1. Plug in the power supply and connect it to the back of the USB HomeBase.
2. Plug the USB cable into the back of the USB home base.
3. Plug the other end of the USB cable into your PC.
At this point, a dialog box appears on your PC instructing you that the system has detected new hardware and it is searching for
the HHP USB-IrDA driver. Unless you have previously installed the USB HomeBase, the OS will be unable to find one and the
Found New Hardware Wizard screen shown below will display on your PC's screen.
In the "Locate Drive Files" dialog, check the CD-ROM drives check box and insert the driver CD provided into the CD tray on
your PC. There are sub-directories in this directory for each type of Windows OS supported. Select stirusb.sys file in the correct
sub-directory for your PC:
• w2k - Windows® 2000
• win98 - Windows® 98
• winme - Windows® Me
At this point, the hardware is installed and operating. You may need to reset your PC to complete the installation process. You
can verify that the USB driver is functioning by watching the COMM LED on the USB home base. It should be flashing red
approximately every three seconds.
Once the USB HomeBase is installed, you can use ActiveSync to connect to a Dolphin 7400. These instructions assume that
ActiveSync v3.1 is installed on your PC.
12 - 11