Grizzly G0462 Owner's Manual page 34

symptom possible Cause
inaccurate turning 1. headstock and tailstock are not properly
results from
aligned with each other.
one end of the
workpiece to the
other.
Can't remove 1. Quill has not retracted all the way back into
tapered tool from
the tailstock.
quill.
2. debris was not removed from taper before
inserting into quill.
Quill will not 1. Keyway not aligned with the quill lock
move forward into
lever.
workpiece when
handwheel is
turned.
-32-
possible solution
1. realign the tailstock to the headstock (page 33).
1. turn the quill handwheel until it forces taper out of
quill.
2. Always make sure that taper surfaces are clean.
1. Align the quill keyway with the quill lock lever as
shown in figure 13, on page 16 and slightly tighten
the lever to engage the keyway.
g0462 Wood Lathe (mfg. since 3/10)