Accessories; Power Supplies; Cables - Teledyne HASTINGS Everywhereyoulook 200 Series Instruction Manual

Flowmeters/controllers

Table of Contents

201/203/205/207 Series Flowmeters and Controllers Instruction Manual

Accessories

1.5.1.

Hastings power supplies are available in one or four channel versions. They convert 100, 115 or 230VAC

to the voltage required to operate the instruments and provide a digital indication of the flow rate.

Hastings power supplies are power limited to no more than 150 VA max (fused) and use a switch

compliant to EN 60601-1. Interface terminals for the analog output signals and a main power on/off

switch are located on the rear panel as well. For safety reasons it is recommended that the power

supply (and on/off switch) be kept near the flow instruments and that the on/off switch not be blocked.

Throughout this manual, when reference is made to a power supply, it is assumed the customer is using a

Hastings power supply. Designs and models offered as Hastings Power supplies change as new technology

becomes available. For knowledge of the most up-to-date Hastings power supplies, please consult either

Hastings sales staff or our website at

WARNING: To prevent the spread of fires in the event of a fault, only use power supplies power

limited to no more than 150 VA. The current available from a power supply used with a 200

series instrument should be no greater than 1.6 A. Hastings power supplies meet these

requirements.

1.5.2.

Cables to power Hastings flow instruments connect from the 15 pin "D" connector on the back of the

power supply directly to any of the 200 series flow instruments. More information about the available

cables can be found on our website at

EAR99 Technology Subject to Restrictions Contained on the Cover Page

http://www.teledyne-hi.com

Page 10 of 28

Table of Contents