Accessories; Power Supplies; Cables - Teledyne HVG-2020B Instruction Manual

HVG-2020B Instruction Manual
WARNING: Do not power with isolated drive circuits that are more than 36 volts above ground
potential or could reach 36 volts in the event of a fault. Failure to heed this warning could
result in serious personal injury and/or damage to the equipment.
Response Time:
CE Mark
RoHS Compliant
Wetted Materials:
Weight (approx.):
Set points:
Connectors:

Accessories

1.3.1. Power Supplies

A 24VDC switching power supply (P/N 12-01-169) is available to directly power the HVG-2020B through
the 2mm bayonet jack.

1.3.2. Cables

The HVG-2020B instruments come with a 9 pin D-connector. A Hastings cable (Part # CB-AF-8-HVG9M) is
available to interface with the standard 15 pin D-connector found on Hastings power supplies. Cables
are available from Hastings in various lengths as well. A variable length cable with bare leads (Part #
CB-LDS-XXX-HVG9M) is also available.
Serial communications cables are available from Hastings (Part # CB-RS232-TRRS). These cables
connect from the 4-conductor 3.5 mm TRRS jack on top of the gauge to a standard 9-pin D connector
used for serial communication on older computers and other adaptors.
A USB cable is available from Hastings (Part # CB-USB-MICRO-B) that will connect from the Type-A
receptacle found on most computers to the Micro-B connector found on the HVG-2020B instruments.
This cable is 6 feet in length and includes ferrites for increased RF immunity.
More information about the power supplies and cables can be found on the Hastings web site:
http://www.teledyne-hi.com
EAR99 Technology Subject to Restrictions Contained on the Cover Page
< 100 ms
EN55011, EN61326, EN61010
YES
304 and 316 stainless steel, glass, nickel, gold plated tungsten
0.6 lb. (0.27 kg) without fitting
open-drain configuration (5 V / 5 mA max input)
2mm bayonet-style power jack (power)
9-pin "D" connector (power, analog signals, TTL serial)
3.5 mm TRRS jack (RS232/485 serial communications)
USB micro-B (virtual COM port for serial communications)
Page 8 of 40