ABB Relion RER615 Manual page 63

1MRS757824 C
Recloser Protection and Control RER615
Point List Manual
IEC 60870-5-101/104 protocol implementation
<45>:= Single command
<46>:= Double command
<47>:= Regulating step command
<48>:= Set point command, normalized value
<49>:= Set point command, scaled value
<50>:= Set point command, short floating point value
<51> := Bitstring of 32 bit
System information in monitor direction
(Station-specific parameter, mark with an "X" if it is only used in the standard
direction, "R" if only used in the reverse direction, and "B" if used in both directions.)
<70> := End of initialization
System information in control direction
(Station-specific parameter, mark each Type ID with an "X" if it is only used in the
standard direction, "R" if only used in the reverse direction, and "B" if used in both
directions.)
<100>:= Interrogation command
<101>:= Counter interrogation command
<102>:= Read command
<103>:= Clock synchronization command (option see 7.6)
<104>:= Test command
<105>:= Reset process command
<106>:= Delay acquisition command
Parameter in control direction
(Station-specific parameter, mark each Type ID with an "X" if it is only used in the
standard direction, "R" if only used in the reverse direction, and "B" if used in both
directions.)
Section 3
C_SC_NA_1
C_DC_NA_1
C_RC_NA_1
C_SE_NA_1
C_SE_NB_1
C_SE_NC_1
C_BO_NA_1
M_EI_NA_1
C_IC_NA_1
C_CI_NA_1
C_RD_NA_1
C_CS_NA_1
C_TS_NA_1
C_RP_NA_1
C_CD_NA_1
57