ABB Relion RER615 Manual page 61

1MRS757824 C
Recloser Protection and Control RER615
Point List Manual
IEC 60870-5-101/104 protocol implementation
(System-specific parameter, mark all used configurations with an "X".)
One octet
Information object address
(System-specific parameter, mark all used configurations with an "X".)
One octet
Two octets
Three octets
Cause of transmission
(System-specific parameter, mark all used configurations with an "X".)
One octet
Selection of standard ASDUs
Process information in monitor direction
(Station-specific parameter, mark each Type ID with an "X" if it is only used in the
standard direction, "R" if only used in the reverse direction, and "B" if used in both
directions.)
<1>:= Single-point information
<2>:= Single-point information with time tag
<3>:= Double-point information
<4>:= Double-point information with time tag
<5>:= Step position information
<6>:= Step position information with time tag
<7>Bitstring of 32 bit
<8>:= Bitstring of 32 bit with time tag
<9>:= Measured value, normalized value
<10>:= Measured value, normalized value with time tag
Table continues on next page
Two octets
Structured
Unstructured
Two octets (with originator address). Originator
address is set to zero if not used
Section 3
M_SP_NA_1
M_SP_TA_1
M_DP_NA_1
M_DP_TA_1
M_ST_NA_1
M_ST_TA_1
M_BO_NA_1
M_BO_TA_1
M_ME_NA_1
M_ME_TA_1
55