Overheat Protection - Singer BFH-2000 Instruction Manual

WARNING: Position the heater carefully. It must not be in front or below
a power socket. It must not be below a shelf, curtains or any other
obstructions. It must be keep at least 100cm from the bath or any spray
system. The heater should to be installed at least 150cm above the fl oor.
(See Picture)
WARNING: As the heater gets warm during normal operation, please
ensure that the wall surface is suitable. Some wall coverings may be
affected by the high temperature.
1. Decide on the position of the air heater on the wall. Use a spirit level to
mark 2 points with a distance of 189 cm apart for the fastening screws.
2. Drill two holes, insert two wall plugs and tighten two screws into the wall
plugs.
Attention: The screw must be fi rmly fi xed to avoid heater falling.
3. Mount the heater to the wall. Make sure the two screws through the slots
on the rear of the heater.
NOTE: Always make sure the unit is secure before use.

OVERHEAT PROTECTION

This heater is protected with an overheat protection that switches off the
appliance automatically in case of overheating. For example: in the case of
total or partial obstruction of the vents, unplug the appliance, wait about 30
minutes for it to cool and remove the object which is obstructing the vents.
Then switch it back on as described above. The appliance should now operate
normally. Should the problem persist, please contact SINGER Service Centre
or SINGER Customer Service for help.
8
ENGLISH