Overheat Protection; Maintenance; Wall Mounting - Singer SCH-17 Instruction Manual

OVERHEAT PROTECTION

This heater is protected with overheat protection that switches off the appliance automatically
in case of severe overheating. In this case, unplug the appliance, wait about 30 minutes for it to
cool and remove any possible cause of overheating, e.g. something covering the heater. Check
for damage to the appliance, the cord and the plug. If there is no damage, plug the unit back
in and switch it on as described above. If the heater still does not turn on, please contact any
SINGER Service Centre or SINGER Client Service.

MAINTENANCE

1. Always remove the plug from the socket-outlet and allow the heater to cool down before
cleaning it.
2. Strictly prohibit using water to wash the appliance; it can be cleaned by a piece of soft damp
cloth with a little neutral detergent. Please do not use other solvent like gasoline.
3. The fan heater must be used or stored after cooled and dried completely
4. To store away the heater, put the heater back into its original package and store it in a clean
dry place.

WALL MOUNTING

Important: before drilling the wall, make sure that the area is free of electrical wires or pipes.
To fi x your convector heater on the wall, use the brackets "A" and "B" provided and appropriate
screws and anchors.
Proceed as follows:
1. Fix the brackets "A", making sure that the distances are as shown in Fig. 1.
2. Hang the heater on the two brackets fi xed on the wall. Insert the two brackets "B" in the
back of the convector base as shown in Fig. 2.
Mark the bracket fi xing points on the wall (when mounted, block the base of the heater in a
fi xed position to prevent it being removed).
3. Remove the heater, drill the wall and insert the anchors.
4. Fix the heater again, inserting the brackets "B" into the base of the heater and fi xing them
to the holes in the wall using the screws.
Now your heater is mounted on the wall. The appliance must not be positioned directly
underneath a socket. Position the appliance in such a way that the plug is easily accessible
even after installation.
6
ENGLISH