V-ZUG CombiSteamer V4000 Operating Instructions Manual page 57

Message
▪ «Please fill with
water – but the
water tank is
still full.»
9.2 Other possible problems
Problem
▪ Appliance is
not working
▪ Illumination is
not working
▪ Cooking time
seems longer
than usual
▪ Steam is not
visible during
steam cycle
▪ Water in door-
mounted con-
densate trough
2
1
Possible cause
▪ Boiler filling error
Possible cause
▪ A household fuse or
circuit breaker has
tripped.
▪ The fuse or circuit
breaker keeps blow-
ing.
▪ Interruption in the
power supply.
▪ Demo mode is
switched on.
▪ Appliance is faulty.
▪ Halogen light is de-
fective.
▪ Appliance only has a
one-phase connec-
tion.
▪ The temperature of
the cooking space is
over 100 °C.
▪ When using applica-
tions with steam,
steam condenses on
the appliance door
and the water that
results collects in the
door-mounted con-
densate trough once
the appliance door is
opened.
Solution
▸ Remove the water tank and then slot
straight back into position.
▸ If the error appears again, note down
the error message in full along with
the serial number (SN) of the appli-
ance (see page 60).
▸ Contact Customer Services.
Solution
▸ Change the fuse.
▸ Reset the circuit breaker.
▸ Contact Customer Services.
▸ Check the power supply.
The demo mode can only be switched
off with the security code.
▸ Contact Customer Services.
▸ Contact Customer Services.
▸ Contact Customer Services.
▸ Connect appliance with a two-phase
connection.
No solution required: steam over
100° C is not visible.
The door-mounted condensate trough is
used to collect condensed steam; resid-
ual water collecting here is normal.
▸ Wipe up any residual water in the
door-mounted condensate trough.
Any residual water in the door-mounted
condensate trough 1 will collect in the
condensate trough 2 when the appli-
ance door is closed. Wipe out the door-
mounted condensate trough to prevent
residual water from collecting in the con-
densate trough.
9 Trouble-shooting
57