V-ZUG CombiSteamer V4000 Operating Instructions Manual page 49

SteamerCleaner
Not suitable for non-anodized aluminium surfaces or plastic surfaces. Wear pro-
tective gloves and protective goggles. Immediately rinse away any splashes with
plenty of water.
Fill the water tank with fresh water and slot into position in the water tank compart-
ment.
▸ Long touch the display.
– The start screen appears.
▸ Select the «Cleaning» application group and confirm with «OK», if required.
▸ Select «Intensive cleaning» and confirm with «OK».
– The settings for «Intensive cleaning» appear in the display.
▸ Set a delayed start, if required (see page 20).
▸ Press «Start» to start «Intensive cleaning».
Removing the accessories and coarse soiling
▸ When the corresponding message appears in the display: Remove the accessories.
Remove the shelf guides and place them across the floor of the cooking space
during the cleaning process (see page 53).
▸ Confirm the message with «OK».
– Steam loosens up any baked-on soiling in the cooking space.
Spraying on the cleaner
▸ When the corresponding message appears in the display: spray on the cleaner.
▸ Confirm the message with «OK».
– The cleaner starts to work.
Wiping down the cooking space
▸ When the corresponding message appears in the display: wipe down the cooking
space.
▸ Confirm with «OK».
– The cooking space is cleaned with steam. Excess cleaner is washed off.
▸ When the corresponding message appears in the display: wipe down the cooking
space and open the appliance door as far as its airing position.
▸ Confirm with «OK».
– The cooking space is dried.
– The following appears in the display: «Process finished».
«SteamerCleaner» was developed especially for this appliance.
▪ Dissolves fat and removes burned-on food debris efficiently
▪ Makes stainless steel shine
▪ The practical spray head reaches all surfaces of the cooking
space, good adhesion
▪ Environmentally friendly, food friendly
▪ No unpleasant odours
8 Care and maintenance
49