Operation and Maintenance Instruction Manual
3.
Components
3.1. Base Unit
The Pur•Chek™ Pro base unit (shown in Figure 3-1) houses the graphic display, infrared bench, internal
battery, electrical connections, and printer module. These components require no maintenance.
IMPORTANT:
disassembly will void the warranty.
3.2. Low Side Vapor Sample Hose
The 6.5 foot (2 meter) low side vapor sample hose configuration is constructed of a polyurethane tube.
See Figure 3-2. A brass flow restrictor acts to reduce pressure at the sample connection point and
reduce the introduction of harmful oil into the machine. The maximum inlet pressure is 500 psig. The hose
is provided with an instrument inlet port mating connector on one end and a 1/4" SAE female flare
coupling nut on the service end.
Analyzer End
3.3. High Side Liquid Sample Hose
The 6.5 foot (2 meter) high side sample hose configuration is constructed of a polyurethane tube with an
oil reservoir. A brass flow restrictor acts to transform liquid refrigerant to vapor at the sample connection
point while the oil trap syringe collects oil and provides a means of expulsion after the test is complete.
The maximum pressure is 500 psig. The syringe is provided with a magnet for attaching it to the tank. It
also is provided with an instrument inlet port mating connector on one end and a 1/4" SAE female flare
coupling nut on the service end. Refer to Figure 3-3.
P/N 2100-9001 Rev 3
There are no serviceable components internal to the instrument, and
Figure 3-1. Base Unit Showing Key Components
Figure 3-2. Low Side Vapor Sample Hose
Service End
(1/4" SAE
Flare Nut)
5