LADY PACK
4.5 Montaggio-Piazzamento
Il montaggio della Macchina viene eseguito, a cura del
Cliente, in funzione della tipologia di imballo con la quale
la macchina è stata spedita.(Vedi Par.4.1).
•
Verificare che il locale sia stato predisposto
all'istallazione della macchina (Vedi Par.4.4);
Devono essere lasciati liberi gli spazi di accesso alla
macchina per consentire all'operatore di poter inter-
venire senza alcuna costrizione ed anche di potere
abbandonare immediatamente l'area di lavoro in caso
di necessità.
Fig.8A - Distanze minime ( in mm ) per la Installazione
Di seguito sono riportati gli spazi richiesti per gli accessi:
•
alla pulsantiera posta nella parte frontale
•
ai gruppi per il cambio formato o per l'intervento in
caso di inceppamenti del prodotto
4.5.1 Macchina senza pianale (Pallet)
Se la macchina è stata spedita senza pianale, si deve
procedere come segue:
•
Togliere la protezione in nylon (film con bolle d'aria),
con un apposito strumento;
•
Pulire la macchina con detergenti non aggressivi;
•
Bloccare la ruote piroettanti;
•
Procedere al collegamento elettrico della macchina
(Par.4.6)
4.5.1 Machine without Pallet
®
IR550
4.5 Assembly - Placing
The assemblage of the Machine comes performed (edited
by the Customer) according to the kind of packaging the
machine have been shipped. (See Par.4.1).
•
Verify that the room have been predisposed for the
installation of the machine (See Par.4.4);
There must be let free spaces around the machine to
allow the operator its intervention without any
constraint but also to be in a position to leave the
working area in case of necessity.
Fig.8A- Minimum distances - in mm - for the Installation
Here following have been brought the required spaces for
the accesses:
•
to the control panel in the frontal part
•
to the groups for the product-size change over or for
the intervention in case of product jams
If the machine have been shipped without pallet, you must
proceed as it follows:
•
Remove the protection nylon (film with beads of air),
with an appropriate tool;
•
Clean the machine with non aggressive detergents;
•
Stop the wheel;
•
Proceed with the electric connection of the machine
(Par.4.6)
17
s . r . i.
0MIR55001-A