Replacing Plunger Release Knob; Removing/Installing The Side Panel; Removing Side Panels - Probasics PB6074 Owner's Operation And Maintenance Manual

NOTE: The rear casters are locking/swivel casters and the front casters
are free-wheeling and non-pivotal.
DETAIL "A" - CASTER ASSEMBLY
Recliner Frame
Hex Head
Screw
Caster
Locknut
Insert
FIGURE 5.5 Replacing Casters

REPLACING PLUNGER RELEASE KNOB

NOTE: For this procedure, refer to FIGURE 5.6.
1. Remove glide from end of frame.
2. Remove retaining ring from end of plunger pin.
3. Slide plunger release knob off the plunger pin.
4. Lift plunger pin and spring out of the frame tube.
5. Insert new plunger pin and spring into the frame so that grooved
end of pin extends below the frame tube.
6. Place plunger release knob over the plunger pin.
7. Snap the retaining ring into groove of the plunger pin.
8. Replace the glide into the end of the frame.
SECTION 5— MAINTENANCE (CONT)
DETAIL "B" - CASTER WHEELS
Nut
Fork
Axle Bolt
Axle Bolt
Caster Wheel
Caster Wheel
Locknut
Locking
Acruator
FIGURE 5.6 Replacing Plunger Release Knob

REMOVING/INSTALLING THE SIDE PANEL

NOTE: For this procedure, refer to FIGURE 5.7 on page 16.

REMOVING SIDE PANELS

1. Press the push buttons near the bottom of the right-side panel.
2. Hold the push buttons in while pulling the panel outward.
3. Repeat STEPS 1 and 2 for the other side panel.
Plunger Pin
Frame
Spring
Glide
Frame Tube
Plunger Release Knob
Retaining Ring
Plastic
Keeper
15