Section 5-Maintenance; Replacing The Back Cushion; Replacing The Footrest Cushion - Probasics PB6074 Owner's Operation And Maintenance Manual

WARNING
After ANY adjustments, repair or service and BEFORE use, make sure
that all attaching hardware is tightened securely - otherwise injury or
damage may result.

REPLACING THE BACK CUSHION

NOTE: For this procedure, refer to FIGURE 5.1.
REMOVING
1. Remove the four long hex screws that secure the back cushion to
the back frame.
2. Remove the four short hex screws that secure headrest bracket to
the back cushion.
3. Repeat for remaining headrest bracket.
INSTALLING
1. Align back cushion with the back frame.
2. Install four long hex screws to secure the back cushion to the back
frame. Securely tighten.
3. Secure the headrest bracket to the back cushion with four short hex
screws.
4. Securely tighten. Repeat for remaining headrest bracket.
12
SECTION 5— MAINTENANCE

REPLACING THE FOOTREST CUSHION

NEVER stand on the footrest or seat when entering or exiting the
recliner. The recliner will tip and bodily injury may occur.
NOTE: For this procedure, refer to FIGURE 5.2 on page 13.
1. Recline the recliner to raise the footrest assembly. Refer to Reclining
2. Remove the four hex screws that secure the existing footrest
3. Align the four mounting holes of the recline mechanism with the
4. Using four hex screws, secure the footrest cushion to the recline
Cushion
Back Frame
FIGURE 5.1 Replacing the Back Cushion
WARNING
the Chair on page 10.
cushion to the recline mechanism.
four mounting holes of the new footrest cushion.
mechanism.
Headrest Bracket
Short Hex Screws
Long Hex
Screws