Replacing Position Lock Lever; Removing Position Lock Lever; Installing Position Lock Lever; Replacing Casters - Probasics PB6074 Owner's Operation And Maintenance Manual

REPLACING POSITION LOCK LEVER

NOTE: For this procedure, refer to FIGURE 5.4.

REMOVING POSITION LOCK LEVER

1. Remove two screws, nylon washers and locknuts securing the
position lock lever to the seat frame.

INSTALLING POSITION LOCK LEVER

1. Secure the position lock lever to the seat frame with the two screws,
nylon washers and locknuts.
Washer
Position Lock
FIGURE 5.4 Replacing Position Lock Lever
14
SECTION 5— MAINTENANCE (CONT)
Seat Frame
Screw
Locknut
Nylon
Lever

REPLACING CASTERS

REPLACING CASTER ASSEMBLY

NOTE: For this procedure, refer to DETAIL "A" of FIGURE 5.5.
1. Place the recliner on its side to gain access to the existing caster
assemblies.
2. Remove the hex screw and locknut that secures the caster assembly
to the recliner frame.
3. Align hole in caster insert with hole in recliner frame and install new
caster assembly.
4. Reinsert and tighten the hex head screw and nut.
5. Return the recliner to its upright position.
WARNING: Periodic inspection of the hex head screws and nuts
is recommended to ensure that they are tight. Time and usage may
cause them to become loose and could cause breakage of the caster
assemblies.

REPLACING CASTER WHEELS

NOTE: For this procedure, refer to DETAIL "B" of FIGURE 5.5
NOTE: When replacing the rear locking caster wheel, note the
orientation of the locking actuator and axle bolt for proper
reinstallation.
1. Remove axle bolt and locknut that secure the existing caster wheel
to the fork.
2. Remove existing caster wheel from fork.
3. Install the new caster wheel into the fork.
4. Install the axle bolt and locknut and tighten securely.