Table of Contents
Advertisement
FIGURE 5.2 Replacing the Footrest Cushion
REPLACING THE RECLINE MECHANISM GUARD
NOTE: For this procedure, refer to FIGURE 5.3.
NOTE: Right and left sides are determined from the user's seated
position.
1. Engage wheel locks.
2. Carefully tip recliner onto the right side. Be sure there are no
obstructions on or around the floor before doing this.
3. Remove the side panel. Refer to Removing/Installing the Side Panel
on page 15.
4. Remove four existing bolts A, B, C, and D from side frame as shown
in FIGURE 5.3.
5. Remove existing recline mechanism guard.
SECTION 5— MAINTENANCE (CONT)
Footrest Cushion
Footrest
Assembly
Recline
Mechanism
Hex Screws
6. Position new recline mechanism guard against the side frame with
the folded edge down.
7. Align holes of new recline mechanism guard with holes on side
frame.
8. Secure new recline mechanism guard to side frame with bolts A, B,
C, and D. Securely tighten.
9. Install the side panel. Refer to Removing/Installing the Side Panel on
page 15.
10. Place chair in the upright position.
NOTE: If binding or pinching of recline mechanism guard occurs,
contact Compass Health Brands Corp. (see back panel of this manual).
11. Carefully tip recliner onto the left side. Ensure there are no
obstructions on or around the floor before doing this.
12. Repeat STEPS 3-10 to install remaining recline mechanism guard.
Rear of Chair
DO NOT
Remove
This Bolt
Bolt A
FIGURE 5.3 Replacing the Recline Mechanism Guard
Side View
Bolt B
Bolt C
Bolt D
Front of Chair
Side Frame
Footrest
Recline Mechanism
Guard
13
Advertisement
Table of Contents
