Emptying The Grass-Catcher; Unblocking The Collector Channel - Racing RAC62PR-3 Original Instructions Manual

Ride-on lawn mower

Table of Contents

5.4.6 Emptying the grass-catcher

3. disengage the blade (☛4.6);

4. engage the parking brake on slopes;

5. hold onto the rear handle and tip up the grass-catcher to empty it;

otherwise the engine stops

If the collector channel gets blocked (due to accumulated grass cuttings filling up the

grass-catcher or an excessively high speed with relation to the quantity of grass cuttings),

you need to:

1. stop forward movement immediately, disengage the blade and stop the engine;

2. remove the grass-catcher;

3. remove the accumulated cuttings, reaching them from the exit of the collector channel.

5.4.8 End of mowing

When you have finished mowing, disengage the blade, lower the engine speed and ride

the machine with the cutting deck in the highest position.

5.4.9 End of work

Once you have finished mowing, stop the machine and engage the parking brake.

1. shift the accelerator lever to «SLOW»;

2. switch off the engine by turning the key to «STOP»:

machine unattended!

The grass-catcher is full when the grass cuttings

remain on the lawn. If you continue mowing with the

grass-catcher full, it may block the collector channel.

To empty the grass-catcher:

1. lower the engine speed;

2. go into neutral (N) (☛4.4) and stop the machine's

forward movement;

This operation can only be done with the blade disengaged,

This job must only be performed with the engine Turned off.

Always take out the ignition key before leaving the

Table of Contents