Table of Contents
Advertisement
3. INSTALLATION
1) Wheels
-
Put upside down the tool.
-
Add the axis on the support
-
On each side add a washer, a wheel, a washer and a pin to lock the wheel in place.
2) Foot pad
-
Keep the tool upside down.
-
In the food pad (2 pieces), put a washer and a screw on each foot pad
-
Localise the two holes on the bar. Screw each foot bar in each hole
3) Handles
-
Put the tool in the normal position.
-
On each side, localise two holes. It is the place where install the handles.
-
Install the handles and then fix them fix the screw and nut.
10
Advertisement
Table of Contents
