Receive Radio Programming; Transmit Radio Programming - Motorola CDR500 Programming Manual

Programming the Professional Series Radios for use with a i20R Repeater Controller
Programming
Figure 10-2. Radio Configuration, Accessory
Pins, Receive Radio
17. Enter the receive frequency for the repeater in
the "Rx" area at "Frequency (MHz)".
18. Select the "Squelch Type:" as "CSQ" (Carrier
SQuelch).
19. Check the "Rx Only Personality" box. Your
screen should appear similar to Figure 10-3.
Figure 10-3. Conventional Personality, Basic,
Receive Radio
10-2
20. Enter any other special programming require-
ments in the appropriate windows.
21. Assign the personality to a zone in the "Per-
sonality Assignment to Zone" selection win-
dows.
22. Program the receive radio.

Transmit Radio Programming

1. Read the Professional Series transmit radio.
2. After the radio is read, double click on "Radio
Configuration" from the opening CPS "Tree
View" window.
3. Click the "Accessory Configuration" tab.
4. Click the "Ext. PTT Audio" dropdown arrow
button. Select "Ext Mic & Flat TX".
5. Click the "Ignition Sense Type:" arrow button.
6. Select "On/Off & Ignition". Your screen
should appear similar Figure 10-4.
Figure 10-4. Radio Configuration, Accessory
Configuration, Transmit Radio
7. Click the "Accessory Pins" tab.
8. Click the "Accessory Package" arrow button.
9. Select "RICK or I20R Tx". Verify pin 3 is
defined as "External Mic PTT (Input)", Active
Level "Low". Your screen should appear simi-
lar to Figure 10-5.
10. Click the "Microphone" tab.
6864110R66-O
CDR500 & CDR700 Repeater Service Manual
March, 2001