Installing The Repeater Controller; Connecting To The Power Supply; Installing The Hln9455 Battery Revert Module - Motorola CDR500 Programming Manual

Wall mount/desktop repeater
Table of Contents

Advertisement

CDR500 & CDR700 Repeater Service Manual
6. Align the holes of the transmit radio with the
M5 holes of the bracket.
7. Attach the transmit radio to the bracket with
two M5 x 0.8 x 8, T25 Torx, pan head, machine
screws from kit HKN4059.
NOTE
DO NOT tighten the screws at this time.

Installing the Repeater Controller

1. Place the repeater controller on the top
mounting tabs (below the internal duplexer)
of the CDR700 internal equipment bracket,
allowing the rear panel to be partially
exposed. The front panel of the controller
faces in the same direction as those of the
radios.
2. Connect the receive radio repeater cable to the
Receive connector of the controller (Figure 3-4
on page 3-6).
3. Connect the transmit radio repeater cable to
the Transmit connector of the controller
(Figure 3-4 on page 3-6).
CAUTION
To avoid damage to cable tabs and radio
components, install cables with locking
tabs up (Figure 3-5).
Repeater
Cables
Figure 3-5. Repeater Controller, Rear View
4. Align the mounting holes of the controller
with the M5 holes of the bracket.
5. Using a T25 Torx screwdriver, secure the con-
troller to the chassis using two M5 x 0.8 x 8
machine screws from kit HKN4059.
NOTE
DO NOT tighten the screws at this time.
March, 2001
Assembling the CDR700
Repeater Housing

Connecting to the Power Supply

Locking Tab
If the (optional) HLN9455 Battery Revert Module is not
being installed, skip to "Installing the Internal Equip-
ment Bracket Module" on page 3-8.
Installing the HLN9455 Battery Revert
Module
If the optional HLN9455 Battery Revert Module will be
used, follow these instructions to install the module
into the CDR700 housing. Orientation for the following
steps is with respect to viewing the front panel from
the outside of the CDR700 housing.
6864110R66-O
CDR700 Desktop Repeater Station
Assembling the CDR700 Repeater Housing
1.
Locate the Y-split power cable, 30-85859M01,
in the HKN4059 cable and hardware kit.
2.
If the HLN9455 Battery Revert Module will be
used, skip to Step 3. Connect the 2-prong
"Ford" connector of the power supply output
connector to the single 2-prong "Ford" con-
nector end of the cable.
3.
Connect one of the 2-prong "Ford" connectors
at the double end of the Y-split cable to the dc
power connector of the transmit radio.
4.
Connect the remaining 2-prong "Ford" con-
nector at the double end of the Y-split cable to
the dc power connector of the receive radio.
5.
Locate the thermal switch mounting clip sup-
plied with kit HKN4059. Slip the mounting
clip onto the thermal switch, from the power
supply. Refer to Figure 3-6.
Figure 3-6. Thermal Switch
6.
Place the thermal switch and mounting clip,
in-between the long fins (5 and 6 on the
antenna connector side) of the transmit
radio's heatsink. Refer to Figure 3-2
7.
Carefully push the thermal switch mounting
clip securely onto fin 6.
NOTE
The fully assembled equipment bracket is
called the "Internal Equipment Bracket
Module".
3-7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdr700

Table of Contents