Programming The Professional Series Radios For Use With A I20R Repeater; Overview; Programming; Programming Tools - Motorola CDR500 Programming Manual

Overview

This section describes the programming and setup of
the Professional Series radios and the Motorola i20R
repeater controller for use in a "campus" repeater con-
figuration. Two Professional Series radios are required;
one operates as the receiver for the repeater and the
other operates as the transmitter of the repeater. For
more information on the i20R, please refer to the fol-
lowing manuals:
6880904Z40 i20R Repeater Controller Service
Manual
6880904Z55 i20R Repeater Controller Radio
Service Software Manual

Programming

Programming Tools

The Professional Series Customer Programming Soft-
ware (CPS) is used to program the receive radio and
the transmit radio (or use archived CPS files for the
radios) for the desired repeater configuration.
The Radio Service Software (RSS) for the i20R is used
to program the parameters for the i20R controller.
Refer to the i20R RSS manual, 6880904Z55, for details.

Professional Series Radios

Receive Radio Programming
1. Read the Professional Series receive radio.
2. After the radio is read, double click the "Radio
Configuration" selection from the opening
CPS "Tree View" window.
3. Click the "Accessory Configuration" tab.
4. Click the "Rx Audio Type:" arrow button.
5. Select "Flat Audio".
6. Click the "Ignition Sense Type:" arrow button.
7. Select "On/Off & Ignition". Your window
should appear similar to Figure 10-1.
8. Click the "Accessory Pins" tab.
9. Click the "Accessory Package" arrow button.
March, 2001
Programming the Professional Series Radios
for use with a i20R Repeater Controller
6864110R66-O
Figure 10-1. Radio Configuration,
Accessory Configuration, Receive Radio
10. Select "RICK or I20R Rx". Verify that pin 8 is
"PL and CSQ Detect/Talkgroup Detect (Out-
put)", Active Level "Low". Your screen
should appear similar to Figure 10-2.
11. "Close" the "Radio Configuration" window.
12. Click on the + indicator next to "Conventional
Personality" selection from the opening CPS
"Tree View" window.
13. Double click on the "Conventional Personal-
ity - 1" selection.
14. Select the "Basic" tab.
15. If the radio is a display model (LCD front
panel), you may enter an "Alias" that will be
displayed such as "Repeater RX".
16. Select a "Channel Bandwidth (kHz):" as
defined by the radio licensing authority. You
have the choice of 12.5, 20 or 25 kHz. (Typical
bandwidths in the United States are 12.5 and
25 kHz for VHF Highband and 450 – 512 MHz
UHF, and 20 kHz for Lowband.)
Section 10
10-1