Motorola CDR500 Programming Manual page 80

Programming the Professional Series Radios for use with a ZR340 Repeater Controller
Programming
Figure 11-2. Radio Configuration, Accessory
Configuration, Receive Radio
Figure 11-3. Radio Configuration, Accessory
Pins, Receive Radio
14. If the radio is a display model (LCD front
panel), you may enter an "Alias" that will be
displayed, such as "Repeater RX".
15. Select a "Channel Bandwidth (kHz):" as
defined by the radio licensing authority. You
have the choice of 12.5, 20 or 25 kHz. (Typical
bandwidths in the United States are 12.5 and
25 kHz for VHF Highband and 450 – 512 MHz
UHF, and 20 kHz for Lowband.)
11-2
16. Enter the receive frequency for the repeater in
the "Rx" area at "Frequency (MHz)".
17. Select the "Squelch Type:" based upon the
squelch type that the repeater will use. The
selections are: "CSQ" (Carrier SQuelch), TPL
(Tone Private Line or CTCSS) and DPL (Digi-
tal Private Line or CDCSS).
18. Check the "Rx Only Personality" box. Your
screen should appear similar to Figure 11-4.
Figure 11-4. Conventional Personality, Basic,
19. Enter any other special programming require-
ments in the appropriate windows.
20. "Close" the "Conventional Personality" win-
dow.
21. Assign the personality to a zone in the "Per-
sonality Assignment to Zone" selection win-
dows.
22. Program the receive radio.
Transmit Radio Programming
1. Read the Professional Series transmit radio.
2. After the radio is read, select "Radio Configu-
ration" from the opening CPS "Tree View"
window.
3. Click the "Accessory Configuration" tab.
4. Click the "Ext. PTT Audio" dropdown arrow
button. Select "Ext Mic Audio".
6864110R66-O
CDR500 & CDR700 Repeater Service Manual
Receive Radio
March, 2001