Motorola CDR500 Programming Manual page 87

CDR500 & CDR700 Repeater Service Manual
Symptom
1. Transmit radio not keying when
a properly identified signal is
presented to receive radio.
2. Transmit radio keying continu-
ously or keying without a prop-
erly identified signal presented
to receive radio.
March, 2001
Table 13-3. Troubleshooting for Repeater Transmit Radio
1a. Controller's repeater function
not enabled (if applicable).
1b. Controller not in Setup state (if
applicable).
1c. Pin 3 of accessory connector pro-
grammed incorrectly.
1d. Loose or bad repeater cable(s).
1e. Receive radio on wrong channel
(personality).
1f. No transmit frequency pro-
grammed into transmit radio.
1g. Incorrect frequency or TPL/DPL
programmed into receive radio.
1h. Accessory connector of receive
radio not programmed correctly
or not operating correctly.
1i. "Busy Channel Lockout" pro-
grammed into transmit radio
and channel is active.
2a. Receive radio on wrong channel
(personality).
2b. Wrong TPL/DPL programmed
into receive radio.
2c. Pin 3 of accessory connector on
controller pulled LOW by an ac-
cessory.
2d. Accessory connector of receive
radio not programmed correctly
or not operating correctly.
2e. Active level for "External Mic
PTT" incorrect.
6864110R66-O
Problem
1a. Enable controller repeater func-
1b. Place controller in setup state
1c. Reprogram pin 3 for "External
1d. Check repeater cable connec-
1e. Set receive radio to correct chan-
1f. Program transmit frequency for
1g. Check receive radio frequency
1h. Check programming of accesso-
1i.
2a. Set receive radio to correct chan-
2b. Check TPL/DPL and repro-
2c. Remove accessory and correct
2d. Check programming of accesso-
2e. Reprogram pin 3 of accessory
Troubleshooting
Solution
tion.
(locally or remotely).
Mic PTT".
tion(s) and replace cable, if nec-
essary.
nel (personality).
transmit radio.
and TPL/DPL and reprogram, if
necessary.
ry connector and reprogram, if
necessary.
Disable the function or wait un-
til channel is inactive.
nel (personality).
gram, if necessary.
LOW condition
ry connector and reprogram, if
necessary.
connector "External Mic PTT"
for correct active level.
13-3