Troubleshooting & Faqs - ABI Attachments RASCAL Series Owner's Manual

Troubleshooting & FAQs
Pinning Scarifiers or Profile Blades to the Rascal
When pinning the scarifiers or profile blades to the Rascal, clip the Lynch pin from the bottom up so rocks and debris don't cause
the Lynch pin to be knocked off and lose a Bent pin and scarifier or possibly damage profile blade (Fig 56).
Marking the wheel Jack for a particular depth
Once the Rascal has been setup for a particular depth, use a marker to mark that depth on the non-painted portion of the wheel
jack. After using the Rascal for other jobs at different depths and it's time to set the height again for a previous setting, just crank
the wheel jack until the bottom of the black portion of the wheel jack lines up with the mark to avoid the time it takes to go thru
the setup procedure. (Fig 57).
Troubleshooting electrical and mechanical issues with Electric Actuator
Refer to the video links below if the Electrical Actuator is not functioning properly.
https://www.youtube.com/watch?v=SEhCApqXQIY
https://www.youtube.com/watch?v=j2K_guT1zo8
NOTE: TO AVOID ELECTRICAL DAMAGE TO THE UNIT BY SPLICING THE RASCAL WIRE HARNESS INTO THE TOW VEHICLE WIRING
SYSTEM AND POSSIBLY REVERSING THE WIRES, OR THE TOW VEHICLE HAVING A POSITIVE GROUND RELAY SYSTEM, CONNECT
THE WIRING HARNESS DIRECTLY TO THE TOW VEHICLE BATTERY (BLACK TO GROUND AND RED TO POSITIVE).
Further informational videos for the use of the PRO and MVP models
https://www.youtube.com/watch?v=m4gxh8ZkVPI
https://www.youtube.com/watch?v=_uS5SmIDRCU
https://www.abiattachments.com/videos/infield-rascal-pro-infield-groomer-by-abi-sports-turf/
Email: support@abiattachments.com
Fig 56.
Fig 57.
57
.
Call Toll Free: 877-788-7253