Table of Contents
Advertisement
Troubleshooting/FAQ
My profile blades are making a chattering noise as I drag.
This is probably due to the profile blades not being level. This can cause them to chatter or create waves in the arena.
To resolve this issue, double check to make sure the upright towers are vertically level when engaged in your
material.
One of my tires is locked up or wobbling.
Remove the hub from spindle and check the bearings. In most cases, tires lock up due to the bearings not being
greased, leading to bearing failure.
My arena footing is too fluffy.
Take the grooming rods out of play. You can then pin above and below the leveling blade, locking it in place. This will
create a compacting effect with the now fixed blade. The finish rake also has a compacting effect and can be adjusted
to carry more material, thereby re-firming your footing.
Tractor is bogging down
First check how much material is on leveling blade. If you see material flowing over the blade, then you can pin the
blade up a hole or two, allowing more material to pass under the blade.
Check the depth of grooming rods and scarifier tips. The deeper you're attempting to rip, the more tension you're
putting on the tractor and the more likely the tractor is going to bog down.
Trouble steering
If your tractor is not following your front tires or you're lacking front-end traction, you might need to add front end
weights. Check the weight requirements in your tractor's owner's manual.
© Copyright 2018 ABI Attachments, Inc.
13
Advertisement
Table of Contents
