Setup and Guide for Grooming Driveways/Sidewalks (cont'd)
Pass 2
Pass 3
This pattern will need to be run a few times at a very slow steady speed. While going down the driveway/
sidewalk, make sure to overlap the pattern. Overlap should be about 6" or enough to remove the ribbon from
the previous pass. When finished running the pattern, go back over it again using the finish rake at a slow and
steady speed to give a finished look.
Another pattern to use is the Crossover Serpentine Pattern. This is the same as the pattern above, but now work
the driveway/sidewalk from each side. This is a down and back pattern. The pattern is illustrated below:
Pass 1
Drag Direction -
Pass 2
Drag Direction -
Pass 3
Drag Direction -
The white arrows indicate the first pass. The gold arrows are the second, and the black arrows the third. Go
down the driveway/sidewalk in the same slow serpentine pattern, then starting at the bottom, repeat the pattern
continuing up and down the driveway/sidewalk until the waves are fully removed.
Email: support@abiattachments.com
The dotted line indicates the center or "crown" of the driveway/sidewalk.
15
Call Toll Free: 877-788-7253