ABI Attachments RASCAL Series Owner's Manual page 50

Options (cont'd)
KIT: MINI BOX BLADE W/SOLID
BLADE
The Mini Box Blade w/Solid Blade kit attaches to the Finish
Rake and is used to move material from high spots and fill in
low spots.
To attach the Min Box Blade to the Rascal, Unscrew and
remove the two wing nuts and remove the two T-clamp
plates (Fig 43).
Slide the Mini Box Blade assembly under the Finish rake so
that the bolts the wing nut threads onto is in the second
comb slot from the end of the comb (Fig 44 and 45).
Lower the unit onto the Mini Box Blade assembly by
cranking the front wheel jack counterclockwise (Fig 46).
Replace T-Clamp plates and tighten wing nuts back onto
both bolts (Fig 47).
Use the closed end of a box wrench large enough to fit over
one wing of the wing nut to use as leverage to tighten the
wing nut tighter (Fig 48).
The unit is now ready to use as a mini box blade. The End
plates (Fig 49) keep the material within the blade area to
help move the material from high spots and fill in low spots.
Fig 43.
Fig 44.
Fig 45.
Visit: www.abisupport.com
Remove wing nut
and T-Clamp plate
from both ends.
Slide Mini Box Blade
assembly under Finish
Rake so that the bolts
that T-Clamp plate and
wing nut go onto slides
in second slot form
comb end on both ends.
Fig 46.
Fig 47.
Fig 48.
Fig 49.
50
Crank wheel jack
counterclockwise
to lower finish rake
onto Mini Box Blade
assembly.
Replace T-Clamp plates
and tighten wing nuts
back onto both bolts.
Use the closed end
of a box wrench large
enough to fit over one
wing of the wing nut
to use as leverage to
tighten the wing nut
tighter.
The End plates keep
the material within
the blade area to help
move the material
from high spots and
fill in low spots.