Table of Contents
Advertisement
5
Remove the o-rings from the banjo bolt and banjo fitting.
Apply a small amount of DOT grease to the new o-rings and install
them.
6
Hold the banjo at the desired angle.
Tighten the banjo bolt to 5 N·m (44.2 in-lb).
7
Insert the bleed block into the caliper.
8
Install the pad retention bolt.
You must bleed your brakes before reinstalling the brake pads.
Installing the brake pads prior to bleeding the brakes could
contaminate the brake pads and lead to a brake failure.
⚠ WARNI NG
T25
Bleed block
2.5 mm
DOT Grease
5 N·m (44.2 in-lb)
Caliper Piston Installation
17
Advertisement
Table of Contents
