5
Install the compression fitting and nut into the lever.
6
Use a flare nut crowfoot with a torque wrench to tighten the
compression nut to 8 N·m (71 in-lb).
Spray isopropyl alcohol on the lever body and clean it with a shop
towel.
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed, brake hose shortening, and brake pad replacement instructions, visit www.sram.com/service.
8 mm flare nut crow foot
⚠ CAUTION
8 N·m (71 in-lb)
Brake Hose Installation
37