Changing Ship's Mains Specifications - Furuno UAIS TRANSPONDER FA-150 Installation Manual

2.2

Changing Ship's Mains Specifications

The AC-DC power supply PR-240 is shipped ready for connection to a 200-230
VAC ship's mains. If the ship's mains is 100 VAC-115 VAC, change the tap
connection and terminal board connection as below. Attach label supplied as
accessories to the front panel according to the ship's mains.
Ship's mains
AC200-230V
AC100-115V
(a)
200-230 VAC
Black
1
2
Grey
3
Terminal board
100-115 VAC
(b)
Black
1
2 Grey
3
Front panel
AC Power Switch
(When connecting DC input, note that the DC power is supplied
if this swqitch is turned off.)
Note: The DC output load must be less than 8A.
16
Tap connection
SEL 230 V
SEL 115 V
Remove screw
and cover.
Cover
1
2
3
4
5
6
7
8
AC FAIL:Connect to Alarm system.
Output Setting: Normal Open
Normal Close
(This setting is for serial no. 022736 and after.)
Terminal board
200-230 VAC 2.5-2.0 A
Below (a)
1φ 50/60 Hz
100-115 VAC 4.0-3.5 A
Below (b)
1φ 50/60 Hz
Relay
3
J4
2
1
SEL
115V
SEL
230V
Tap connection
(Pull out to disconnect.)
Attach appropriate label.
Set plug to 1 & 2 pins of J4
Set plug to 2 & 3 pins of J4 (Factory setting)
Label
Front panel
Coil
Heat sink