Connection For J602; Wiring Wago Connector; Connection For P608; Connecting Connector Assemblies Inside Processor Unit - Furuno FAR-2157 Installation Manual

5. Connect J602 (attached at step 3) to the GYRO CONVERTER board with two VH connector
assemblies 03-2089 (3P) and 03-2090 (5P).

Connection for J602

2
PPL
From J4
BLU
GRN
YEL
ORG
RED
From J5
BRN
VH connector assy.
2
03-2089 (5P)
VH connector assy.
2
03-2090 (3P)

Connecting connector assemblies inside processor unit

6. Confirm gyrocompass specifications and set up the DIP switches and jumper wires on the
GYRO CONVERTER board according to gyrocompass connected:
• Setting jumper wires and DIP switches by gyrocompass specifications: page 4-6
• Setting jumper wires and DIP switches by make and model of gyrocompass: page 4-7
• Location of jumper wires and DIP switches: page 4-8

Wiring WAGO connector

Terminal opener
Wire
Procedure
1. Twist core.
2. Press terminal opener downward.
3. Insert wire to hole.
4. Remove terminal opener.
5. Pull wire to confirm that it is secure.
To J602
P5
P4
J5
P608
Press downward.
1
WAGO connector
Twist
To P608
P7
P603
GYRO CONVERTER
J1
64P1106A
J4
J7
J602
J603
TB
03P9342

Connection for P608

P608
YEL
ORG
RED
NH connector assy.
1
03-2091 (5P)
XH-PH connector assy.
03-2088 (6-14P)
P1
4-3