Contents Of Flush Mount Kit For Rcu-014/015/016 - Furuno FAR-2157 Installation Manual

Flush mounting
Use the optional flush mount kit FP03-09870 (Code No. 008-535-630) to flush mount the control
unit RCU-014, RCU-015 and/or RCU016 in a console.

Contents of flush mount kit for RCU-014/015/016

Name
Mounting plate
Hex bolt
Wing screw
Pan head screw
1. Prepare a cutout in the mounting location as shown in the figure below.
Flush mount cutout for RCU-014
2. Set the control unit to the cutout.
3. From the rear side, attach the mounting plate to the control unit with four screws.
4. Screw the wing screw to each mounting plate and then insert hex bolt to each wing screw.
5. Fasten each wing screw and then fasten the hex nuts as shown in the figure below.
#70
# Minimum recommended service space
Flush mount mounting dimensions for control unit RCU-014 (left) and RCU-015/RCU-016
1-12
Type
03-163-7531
M5
M5 × 40
M4 × 12
±2
388
Note:
Qty
4
4
4
4
170±2
Flush mount cutout for RCU-015 and RCU-016
#70
171
< =
P 10
176±2
150±2
To change location of
cable entrance, see
page 1-14.