Pre-Installation And Application Warnings - Directed Directechs DB3 Installation Manual

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in pricing
accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Š No Immobilizer bypass - one (1) working OEM key must be wired into the vehicle to complete the installation.
Š Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
Š Refer to the "Vehicle connections" following the installation diagram.
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin or NOT
[2]
supported in data.
Refer to the Immobilizer Interface section for more information about the Key Wrap.
[3]
4
403.VW15 2.00 2020 Volkswagen Tiguan
©2021 VOXX•DEI LLC. All rights reserved.
Keys required for Keys required
1
programming for operation
1