Erasing Individual Marks; Changing Mark Attributes - Furuno GP-1610CF Operator's Manual

6.3 Erasing Individual Marks

Marks can be erased individually or collec-
tively. How to erase marks collectively will
be discussed later.
1. Press the CURS key to turn on the cursor.
2. Operate the Cursor Pad to place the cur-
sor on the mark to erase.
3. Press the CLR key.

6.4 Changing Mark Attributes

Changing mark shape
1. Press the MENU key.
2. Press the [2] key to select TRACK/
MARK SETUP.
TRACK/MARK SETUP
MARK SHAPE
LINE TYPE
MARK COLOR
RED YEL GRN LBLU PPL BLU WHT
TRACK COLOR
RED YEL GRN LBLU PPL BLU WHT
MARK SIZE
L
PLOT
ON
PLOT INTVL TIME
00 10
: Cursor
Figure 6-3 Track/mark setup menu
3. Press to select MARK SHAPE.
4. Press t or s to select shape desired.
5. Press the MENU key.
6-2
S
OFF
DIST AUTO
00.10nm
ESC: Esc
Changing line type
Marks can be connected with solid or dashed
lines. This is useful for denoting an important
area such as a good fishing spot. To select line
type and connect marks do the following:
1. Press the MENU key.
2. Press the [2] key to select TRACK/
MARK SETUP.
3. Press or to select LINE TYPE.
4. Press t or s to select any line type other
than "single dot," the default setting,
which provides for no connection of
marks.
5. Press the MENU key.
To enter marks without connecting them, se-
lect "single dot" in step 4 in the above proce-
dure.
Changing mark color
Marks can be displayed in red, yellow, green,
light blue, purple, blue or white.
1. Press the MENU key.
2. Press the [2] key to select TRACK/
MARK SETUP.
3. Press or to select MARK COLOR.
4. Press t or s to select color desired.
5. Press the MENU key.
Changing mark size
You may change the size of marks to small or
large.
1. Press the MENU key.
2. Press the [2] key to select TRACK/
MARK SETUP.
3. Press or to select MARK SIZE.
4. Press t or s to select Large or Small.
5. Press the MENU key.