Initial Settings - Furuno GP-1610CF Operator's Manual

1.6 Initial Settings

1-24
Sensor connection
This section should be done with the boat in water.
1. Turn on the power and press the MENU key.
2. Press the [0] key.
3. Press the [5] key to select SENSOR SETUP.
SENSOR SETUP
SPD SENSOR
STW
TEMP SENSOR
OWN
SPD CALIB
-00%(-50~+50)
TEMP CALIB
+000 C
DEPTH CALIB
+0.0m
: Cursor
ESC : Esc
Figure 1-34 Sensor setup menu
4. Select source of ship's speed; STW (Speed-Through-Water):
local sensor, SOG (Speed-Over-Ground): GPS.
5. Press twice to select SPD CALIB.
6. If speed reading is higher or lower than actual speed you may
apply an offset to compensate for this. Enter offset with plus or
minus sign. The
7. If a water temperature sensor is installed, press
TEMP SENSOR.
8. Press t to select OWN. (NMEA is for water temperature data
from external source.)
9. Press twice to select TEMP CALIB.
10. If temperature reading is higher or lower than actual tempera-
ture you may apply an offset to compensate for this. Enter off-
set with plus or minus sign. The
plus and minus.
11. Press to select DEPTH CALIB.
12. Enter ship's draft, if applicable. Normally, depth is measured
from the transducer so enter positive figure.
13. Press the MENU key.
Autopilot or remote display connection
1. Press the MENU key.
2. Press the [0] key.
3. Press the [6] key.
SOG
NMEA
: +/-
key alternately displays plus and minus.
key alternately displays
to select