Buzzer Type Selection; How To Set An Alarm - Furuno GP-33 User Manual

6. ALARMS
Message and meanings
Message
XTE ALARM!
TIME ALARM!
SPEED ALARM!
ARRIVAL ALARM!
TRIP ALARM!
ODOMETER ALARM!
ANCHOR WATCH!
NO WAAS SIGNAL!
Note: The message screen also shows equipment trouble. See section 8.3.
6.2

Buzzer Type Selection

The buzzer sounds whenever an alarm setting is violated. You can select the type of
buzzer as follows:
1. Press the MENU/ZOOM key twice to show the main menu.
2. Select [Alarms], and press the ENT key.
3. Select [Buzzer], and press the ENT key.
4. Select buzzer type, and press the ENT key.
Short: A short beep sounds.
Long: Three long beeps sound.
Continuous: Continuous long beeps sound until a key is pressed.
5. Press the MENU/ZOOM key twice to close the menu.
6.3

How to Set an Alarm

Set alarms as below:
Note: For the Anchor alarm, press the WPT/MOB key to enter the waypoint at own
boat's position, and set it as destination referring to paragraph 5.2.1.
1. Press the MENU/ZOOM key twice to show the main menu.
6-2
The boat is off its intended course by the range set.
The time set has come.
The boat's speed is higher than the range set.
The boat is approaching the arrival area.
The boat has traveled further than the preset trip distance.
The boat has traveled the total distance set.
The boat has moved a certain distance (when it should be at rest).
WAAS signal cannot be found.
Meaning