Mitsubishi Electric FR-CC2-P Instruction Manual page 20

Removal of the front cover (upper side)
(a)
(a) With the front cover (lower side) removed, loosen the mounting screws on the front cover (upper side). (These screws cannot be
removed.)
(b) While holding the areas around the installation hooks on the sides of the front cover (upper side), pull out the front cover (upper
side) using its upper side as a support.
(c) With the front cover (upper side) removed, wiring of the control circuit or the RS-485 terminals can be performed.
Reinstallation of the front cover
(a)
(a) Insert the upper hooks of the front cover (upper side) into the sockets of the converter unit.
Insert the upper hooks of the front cover (upper side) into the sockets of the converter unit.
(b) Tighten the mounting screw at the lower part of the front cover (upper side).
(c) Fasten the front cover (lower side) with the mounting screws.
NOTE
• Fully make sure that the front cover is installed securely. Always tighten the mounting screws of the front cover.
(b)
Loosen Loosen Loosen
(b)
Removal and reinstallation of the front cover
(c)
(c)
Fasten Fasten Fasten
INSTALLATION AND WIRING
Fasten Fasten Fasten
19
2