Mitsubishi Electric FR-CC2-P Instruction Manual page 75

Operation panel
4.1
Operation panel
4.1.1
Components of the operation panel
Install the operation panel of the inverter on the converter unit.
To mount the operation panel on the enclosure surface, refer to
No. Component
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
(l)
(m)
74
BASIC OPERATION
(j)
(k)
(l)
(m)
Name
— Not used.
MON: ON to indicate the monitor mode. Quickly blinks twice intermittently while the
Operation panel protective function is activated.
status indicator Slowly blinks in the display-off mode.
PRM: ON to indicate the parameter setting mode.
— Not used.
— Not used.
Shows the monitored status, parameter number, etc.
Monitor (5-digit LED)
(Using Pr.774 to Pr.776, the monitored item can be changed.)
— Not used.
— Not used.
STOP/RESET key Resets the converter unit when the protective function is activated.
Changes the parameter settings.
Press the setting dial to perform the following operations:
Setting dial
 To display a monitored item set in Pr.992
 To display a fault history number in the fault history mode
Switches to different modes.
MODE key Holding this key for 2 seconds locks the operation. The key lock is invalid when Pr.161
= "0" (initial setting). (Refer to
Enters each setting.
If pressed during the operation, monitored item changes as the following:
(Using Pr.774 to Pr.776, the monitored item can be changed.)
SET key
When the initial setting is set
Converter
output voltage
Goes back to the previous display.
ESC key
Holding this key for a long time changes the mode back to the monitor mode.
— Not used.
page 55.
(a) (b) (c)
Description
page 90.)
Input Electric thermal relay
current function load factor
(d)
(e)
(f)
(g)
(h)
(i)