Table of Contents
Advertisement
7) Peel off T94, and then pull out flexible board.
Unsolder 3 lead wires (0-J201, 0-Q200).
(0-J201)
White
Shielding wire
8) Remove 0-T100 from DT (3 places) as shown in Fig.32.
9) Lift up 0-T100, and then unsolder 4 lead wires (0-S250, B116, B118).
Green (B116)
[Note of Assembly] Bottom of body
Arrange the lead wires securely with care that
0-T100 is not projected from the Main body as
shown in Fig.34.
IC
IC
Screws
2-9. Upper Right Side (2)
1） 3 lands on T64.
2） Disconnect the flexible board of 0-O100 from connector
terminal.
Pink (0-Q200)
Motor
27830 -8/40-
DT(3x7)
DT(5x10)
T94
DT(3x7)
Red (0-S250)
Black (0-S250)
Pink (B118)
Fig.33
Fig.34
Fig.32
Fig.35
Advertisement
Table of Contents
