Pentax ist Service Manual page 36

***** MAIN MENU *****
[ 3 ] AF AND RELATED ADJUSTMENTS
***** AF ADJUSTMENT MAIN MENU *****
CCD POSITION ADJUSTMENT ‑‑‑> [ 1 ]
AGC LEVEL ADJUSTMENTS ‑‑‑> [ 2 ]
MONITOR OFFSET ADJUSTMENT ‑‑‑> [ 3 ]
UNIFORMITY ADJUSTMENT ‑‑‑> [ 4 ]
SATURATED OUTPUT AND TEMP ADJUSTMENT ‑‑‑> [ 5 ]
FOCUS ADJUSTMENT ‑‑‑> [ 6 ]
MAIN MENU ‑‑‑> [ 0 ]
***** CCD POSITION ADJUSTMENT MENU *****
CCD POSITION SQUARE ADJUSTMENTS ‑‑‑> [ 1 ]
CCD POSITION CROSS ADJUSTMENTS ‑‑‑> [ 2 ]
CCD POSITION CHECK ‑‑‑> [ 3 ]
CCD FOCUS ADJUSTMENT ‑‑‑> [ 4 ]
TO AF‑MAIN‑MENU ‑‑‑> [ 0 ]
[ 1 ] CCD POSITION SQUARE ADJUSTMENTS
***** CCD POSITION SQUARE ADJUSTMENTS *****
MOUNT CCD ADJUSTING TUBE (SQUARE) ONTO CAMERA.
SET LIGHT SOURCE TO LV 12.
SET FOCUS‑MODE SW OF CAMERA TO MF.
AFTER CONFIRMING ABOVE, PRESS KEY [ Y ].
WHEN YOU RETURN TO FRONT MENU, PRESS KEY [ N ].
***** CCD POSITION ADJUSTMENTS *****
HD ‑‑‑‑‑: * :‑‑‑‑‑ (SCREW 3)
HC ‑‑‑‑‑: * :‑‑‑‑‑ (SCREW 3)
HU ‑‑‑‑‑: * :‑‑‑‑‑ (SCREW 3)
VR1 ‑‑‑‑‑: * :‑‑‑‑‑ (SCREW 1)
VC ‑‑‑‑‑: * :‑‑‑‑‑ (SCREW 1)
VR1 ‑‑‑‑‑: * :‑‑‑‑‑ (SCREW 1)
ADJUST WITH TOLERANCE.
■Symbols of CCD position
VL3
VL1
** SQUARE **
HU
HC
VR3
HD
VC VR1
27830 -35/40-
[ 2 ] CCD POSITION CROSS ADJUSTMENTS
***** CCD POSITION CROSS ADJUSTMENTS *****
MOUNT CCD ADJUSTING TUBE (CROSS) ONTO CAMERA.
SET LIGHT SOURCE TO LV 12.
SET FOCUS‑MODE SW OF CAMERA TO MF.
AFTER CONFIRMING ABOVE, PRESS KEY [ Y ].
WHEN YOU RETURN TO FRONT MENU, PRESS KEY [ N ].
***** CCD POSITION ADJUSTMENTS *****
HC ‑‑‑‑‑: * :‑‑‑‑‑ (SCREW 1)
VC ‑‑‑‑‑: * :‑‑‑‑‑ (SCREW 1)
JUST A MOMENT
■Position of Adjusting screws
0-M100
SCREW 1
SCREW 2
** CROSS **
If you push Z,
this adjustment ends.
SCREW 3