Table of Contents
Advertisement
5-9. 0-T27
1) Stick on DT (4x4) to a hollow at the main body.
2) Stick on DT (3x7) to 0-T27, and then fix it to the main body.
5-10. D1
1） Apply G126 to shafts (2 places) of the main body.
2） D4, D5, D6
[CONF.] Make sure that D4 should be dropped by
self-weight when the main body is reversed.
.
3） D2, D3
4） D1, TY-CNL-F1.7x2.0 (x2), DT (7x10)
5-11. 0-E000
1） Install 0-E000 from access the motor side.
2） A50 (x3) (Screw with shoulder)
[NOTE]
0-E000 has a movement approx. 0.1mm
to stabilize the shutter speed at 1/4000.
3） A25 (Light seal tape 13x10)
[CAUTION] A25 should be stuck between
the main body and 0-E000 as no gap.
5-12. R101 (Assy.)
1) Install R101 from access the DX contact side.
2) TY-CNL-D1.7x5.0
5-13. Back Cover
3) Set the back cover to the main body, and then install it by A207.
[CAUTION] A207 should come through on the flexible board of 0-T200.
4) Fix the flexible board to the main body by DT (7x14) during full opened cover condition.
0-T200
G126
Fig.101
Fig.104
A207
DT(7x14)
Fig.105
27830 -20/40-
DT(4x4)
Fig.100
D4･D5･D6
D3
D1
D2
Fig.102
A50
0-E000
R101
Fig.103
TY-CNL-D1.7x5.0
0-T27
DT(3x7)
TY-CNL-F1.7x2.0
DT(7x10)
A25
2mm
Fig.106
Advertisement
Table of Contents
