Table of Contents
Advertisement
6） Discharge electricity of the main capacitor.
-1. Peel off the BT (10x30) from the flash PCB.
-2. Discharge electricity of the main capacitor with
a resistor of 100Ω-1kΩ.
Land of the blue lead wire (29 Xe+) on 0-Q2000
Hot shoe (A322) or Battery contact: Minus side (A34)
[Note of Assembly]
Remove the TY-CNL-F1.4x4.0 that has been installed
temporarily, and then install the temporary bottom
cover and battery cover.
Step to final adjustments and confirmation (p.27).
1-2. Side Cover (A161)
TY-CNL-D1.7x3.0Ni (x2)
1-3. Grip (A150)
1） A151
2） 2 screws (TY-CNL-E 2.0x7.0, TY-CNS 1.7x4.5)
[NOTE] A185 has already been removed at step 1-1-(2)).
3） A150, A8, A7
1-4. Front Cover (A160)
1） Set the Focus mode switch at [AF.S].
2） TY-CNL-D1.7x3.5Ni (x5)
W3 (t=0.15, x2)
3） Remove A160 while lifting up the release
socket side of front cover.
1-5. Top Cover (0-A301)
1） 4 lead wires (0-Q200)
[Note of Assembly]
The lead wires on the flash PCB should be arranged in good order to prevent pinch by
the motor or electronic parts as shown in Fig.10.
Stick T94 (10x13) and BT (10x30) as shown in Fig.11.
A161
TY-CNL-D 1.7x3.0Ni
Fig.6
Black (0-Q100)
Brown
Blue
Green
Fig.10
27830 -3/40-
TY-CNL-E 2.0x7.0
DT(5x25)
A151
(A185)
DT(25x50)
A154
A152
TY-CNL-D
1.7x3.5Ni
Fig.8
T94
BT(10x30)
BT(10x30)
Fig.4
Fig.5
A153
DT(3x15)
A8
A150
TY-CNS 1.7x4.5
Fig.7
W3(t=0.15)
A160
TY-CNL-D
1.7x3.5Ni
Fig.9
Fig.11
A7
Advertisement
Table of Contents
