Table of Contents
Advertisement
4-7. 0-O170
1） TY-CNL-F1.7x4.0 (x2)
2） M14, 0-O170 (Remove adhesive)
[Note of Assembly]
Temporarily installation and position
adjustment are required.
4-8. 0-L101
1） Remove M7 upward.
2） Peel off M19 (SI black mat tape) and other light seal tapes.
[CAUTION] Carefully peel off M19, because the
SI prism is adhered behind M19.
3） T94, TY-CNL-D1.7x3.5 (x2), M9
4） Remove the silicone (2 places).
5） Remove 0-L101 gently, using care that
SI prism is not touched to the Front housing assy.
6）M3
[Note of Assembly]
Apply silicone to the place as shown in Fig.71, and
leave them until they become hard.
Stick M19 on 0-A101 as shown in Fig.72, using care
that do not apply a stress to the SI prism.
4-9. 0-J201
TY-CNL-D1.7x4.0
4-10. 0-B52 and Related Parts
For disassembly, refer to Fig.74.
[Note of Assembly]
Temporarily installation of 0-B52 and the position
adjustment of 1
4-11. A104 and Related Parts
For disassembly, refer to Fig.74.
[Note of Assembly]
Five W98 (t=0.2) are fixed by a
small amount of Super- X (Black).
A104
A119
0-J201
and 2
mirror are required.
st
nd
W98(t=adj)
A118
A105
A145
27830 -14/40-
0-O170
Super-X
Fig.70
TY-CNL-D
1.7x3.5
0-L101
TY-CNL-D 1.7x4.0
Fig.73
A110
0-A108
0-A126
TY-CNL-D 1.7x3.0
(C.6172300)
TY-CNL-F 1.4x3.5
(C.6191351)
DT(3x7)
T301
A148
A146
A147
A145
A143
M7
M9
Silicone
M3
M19
SI-prism
M120
DT(3x7)
M23
M4
B65
M10
DT(3x7)
TY-CNL-F 1.4x2.5
(C.6171251)
I331
T65
I332
TY-CNL-D 1.4x2.5
(C.6171251)
TY-CNL-F
1.7×4.0
M14
Loctite
T94
Fig.71
Fig.72
M21
0-B52
B41
B66
B63
B57
B62
B58
B59
TY-CNL-G 1.7x2.5
(C.6202251)
Fig.74
Advertisement
Table of Contents
